DMX Branch 419™
Introduction
Introduction: To optimize the performance of this product, please
read these operating instructions carefully to familiarize yourself with
the basic operations of this unit. The DMX Branch 419™ is a 4-way
DMX signal distributor by Elation Professional®
user to split and boost a DMX signal anywhere in a DMX signal path,
a function that is typically not recommended without the use of device
similar to this one. The unit has been durably constructed in a rack
mount chassis for convenient rackmount storage.
Unpacking: Thank you for purchasing the DMX Branch 419™ by
Elation Professional® Every DMX Branch 419™ has been thoroughly
tested and has been shipped in perfect operating condition. Carefully
check the shipping carton for damage that may have occurred during
shipping. If the carton appears to be damaged, carefully inspect your
unit for damage and be sure all accessories necessary to operate the
unit have arrived intact. In the event damage has been found or parts
are missing, please contact our toll free customer support number for
further instructions. Please do not return this unit to your dealer with-
out first contacting customer support at the number listed below.
Customer Support: Elation Professional® provides a customer sup-
port line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
ments or suggestions. For service related issue please contact Elation
Professional® Service Hours are Monday through Friday 9:00 a.m. to
5:00 p.m. Pacific Standard Time.
Voice:
(323) 582-3322
(323) 582-3108
E-mail:
Warning! To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures
warranty.
Elation Professional®
Los Angeles Ca. 90058
Please do not discard the shipping carton in the trash. Please recycle
when ever possible.
Revised 5/02
DMX Branch 419™
Controls and Functions
DMX Branch 419™
Controls and Functions
7. Red DATA (+) LED - Indicates that pin 3(+) polar positive, is making
1
2
3
proper connection through out the data stream of the given output.
8. Fuse Holder - This unit is used to house the protective overload
fuse. The fuse type is a GMA 0.5A 250V 5x20mm always replace with
the same type fuse. To replace the fuse, please see the fuse replace-
ment section on page 4.
9. Power Input: This device is designed to accept an AC signal of ei-
ther 120v~50/60Hz or 220v~50Hz, be sure the power supply for your
unit matches that of printed label on the unit.
8
9
4
5
6
7
DMX Branch 419™
Operation
The DMX Branch 419 is a 4-way DMX distributor with a 3-pin and 5-pin
XLR input jack. Be sure to never connect more than one input source
to this unit at a time. Two input jacks have been provided for universal
connectivity only. This unit takes the incoming DMX signal and safely
boost and splits the signal into four separate output channels. Each
output channel and the input channel are completely electronically
isolated from each other to avoid unwanted signal crosstalk that can
cause erratic behavior.
1. Link Out / Terminate Selector - This switch is primarily meant for
troubleshooting. When the switch is in the “Terminate” (left) position,
The Parallel Link Output is turned off. You cannot link any more units.
When the switch is in the “Link Out” position, it allows for signal of the
parallel DMX output for linking more DMX Branch-419 units.
All four output channels have independent output drivers. A 3-pin and
5-pin output connector is provided per a channel allowing the output of
each channel to double when using both connectors at once.
2. Parallel DMX Output - These Outputs are used to link out to a sec-
ond DMX Branch-419. To be used for linking only.
3. Boosted DMX Output Section - The four DMX output channels are
completely Optically and Electronically Isolated and feature an inde-
pendent driver that boosts the DMX signal.
DMX Branch 419™
Unit Cleaning:
Due to fog residue, smoke, and dust cleaning the exterior of the case
may become necessary. Please follow the guidelines printed below
for proper cleaning.
Cleaning
4. Power Switch - This is the main power switch and turns power on
and off. When power is off the Parallel DMX Output Jacks (2) may be
Boosted DMX Output Section (3)
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Always be sure to dry all parts completely before plugging
the unit back in.
5. DMX Input - These jacks are used to capture an incoming DMX
signal from either a DMX controller or any other DMX device sending
a DMX output signal.
6. Green DATA (-) LED - Indicates that pin 2(-) polar negative, is mak-
ing proper connection through out the data stream of the given out-
put.
DMX Branch 419™
2 Year Warranty
DMX Branch 419™
Specifications
2 YEAR (730 DAYS) LIMITED WARRANTY
A. Elation® hereby warrants, to the original purchaser, Elation® products to be free of
manufacturing defects in material and workmanship for a period of one year (365 days)
from the date of purchase. This warranty shall be valid only if the product is purchased
within the United States of America, including possessions and territories. It is the owner’s
responsibility to establish the date and place of purchase by acceptable evidence, at the
time service is sought.
B. For warranty service, send the product only to the Elation® factory. All shipping charges
must be pre-paid. If the requested repairs or service (including parts replacement) are
within the terms of this warranty, Elation® will pay return shipping charges only to a des-
ignated point within the United States. If the entire instrument is sent, it must be shipped
in its original package. No accessories should be shipped with the product. If any acces-
sories are shipped with the product, Elation® shall have no liability whatsoever for loss of or
damage to any such accessories, nor for the safe return thereof.
Specifications and improvements in the design
of this unit and this manual are subject to change without any
prior written notice.
C. This warranty is void if the serial number has been altered or removed; if the product is
modified in any manner which Elation® concludes, after inspection, affects the reliability of
the product; if the product has been repaired or serviced by anyone other than the Elation®
factory unless prior written authorization was issued to purchaser by Elation®; if the product
is damaged because not properly maintained as set forth in the instruction manual.
D. This is not a service contract, and this warranty does not include maintenance, clean-
ing or periodic check-up. During the period specified above, Elation® will replace defective
parts at its expense, and will absorb all expenses for warranty service and repair labor by
reason of defects in material or workmanship. The sole responsibility of Elation® under
this warranty shall be limited to the repair of the product, or replacement thereof, including
parts, at the sole discretion of Elation®. All products covered by this warranty were manu-
factured after January 1, 1990, and bear identifying marks to that effect.
E. Elation® reserves the right to make changes in design and/or improvements upon its
products without any obligation to include these changes in any products theretofore
manufactured.
F. No warranty, whether expressed or implied, is given or made with respect to any acces-
sory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by Elation® in connection with this product, including war-
ranties of merchantability or fitness, are limited in duration to the warranty period set forth
above. And no warranties, whether expressed or implied, including warranties of merchant-
ability or fitness, shall apply to this product after said period has expired. The consumer’s
and or Dealer’s sole remedy shall be such repair or replacement as is expressly provided
above; and under no circumstances shall Elation® be liable for any loss or damage, direct
or consequential, arising out of the use of, or inability to use, this product.
G. This warranty is the only written warranty applicable to Elation® Products and super-
sedes all prior warranties and written descriptions of warranty terms and conditions here-
tofore published.
©Elation Professionals®
Elation World Headquarters:
H. Lamps are not covered under this or any other warranty either written or implied.
4295 Charter Street Los Angeles, CA 90058 USA
Tel: 323-582-3322 / Fax: 323-582-3108
|