FPX 32 DVS Artisan Face
Charcoal 98500507
Antique Copper 98500508
Antique Nickel 98500509
Compatibility
• DVS Insert
• 31 DVI Insert
NOTE: On newer units (2008 or later), leave the glass on and move the face connector to the forward
position (see illustration below). For older units, remove the glass.
Remove the face connector bracket
from the heater (on both sides).
Re-attach the face connector to the
heater using the forward mounting holes.
Face Connector
Bracket
Warnings
Plated Surfaces Warning:
Denatured
Alcohol
Any marks left on the optional plated surface may become etched-in by the heat of the
appliance. Use denatured alcohol and a soft cloth to clean.
Soft Cloth
Copper Surfaces Warning:
Anti-
Use the included anti-oxidizer to clean the optional copper surface. See the included instruction
sheet for full details.
Oxidizer
Soft Cloth
Warning:
Make sure the heater has fully cooled prior to conducting service.
Packing List
10-24 Nuts
1/4-20
Screws
Page 1 of 4
17601079 - 5/10/10
© Travis Industries, Inc.
FPX 32 DVS Artisan Face
Charcoal 98500507
Antique Copper 98500508
Antique Nickel 98500509
Face Installation
Attach the face using the four
bolts included with the face.
Adjustable
Wrench
Make sure the door does
not open while installing.
Page 3 of 4
17601079 - 5/10/10
© Travis Industries, Inc.
FPX 32 DVS Artisan Face
Charcoal 98500507
Antique Copper 98500508
Antique Nickel 98500509
Opening the Control Door
Warning:
The face becomes very hot during operation. Use the included handle open the control and
take care to not touch any of the hot surfaces.
Use the pull tool
on either side to
disengage the
hinges.
Pull Tool
(included
with face)
Control Door
Note how the hooks on the tool insert
into the triangle-shaped holes.
When removing the
pull tool, make sure
it does not damage
the hearth.
Adjusting the Control Door
The control is adjsuted at the factory. See the directions below if further adjustment is necessary.
Bullet Catch
Back of Face (with face removed)
Back of Bullet
Catch
These two nuts hold the
bullet catch assembly.
If the top of the control
door is not aligned,
these nuts can be
loosened to re-align the
bullet catch assembly.
Access
Panel
Adjust this nut to tighten
or loosen the friction of
the hinge.
This bullet-shaped device holds the control door
upright. To tighten or loosen the catch, simple
rotate it (it is threaded inside the assembly).
Page 4 of 4
17601079 - 5/10/10
© Travis Industries, Inc.
|